Search
Filters
Close

AquaClear SF

AquaClear SF is a highly soluble preserving compound, whose properties are ideal for a broad spectrum of biological conditions that are involved in the decomposition of water. AquaClear SF is the only proven biocide solution to the tedious and expensive task of maintain optimum water bath integrity. 

Used in the right concentration, it is highly effective against bacteria and fungi. It is also non- hazardous and its environmentally friendly formula does not require you to follow special disposal instructions. This formula has also been enhanced by the addition of special cleaning agents, that will contribute to make subsequent cleaning easier to perform by reducing the effect of microorganism build-up around the bath walls, as well as provide secondary protection to units with recirculating systems.

Its preserving properties are maintained even in other anionic, cationic, and most non-ionic systems not intended for human consumption. Additionally, AquaClear SF is clearly effective against Pseudonomas and Aureginosa, but since it is less effective in alkaline systems, and for best results, it is recommended that it be used only with dionized water .

Dissolution experts recommend that water in the bath be changed once per week to comply with GLP's (Good Laboratory Practices) as well as to maintain optimum visibility and general aesthetic appearance. They also point that the properties inherent in degraded water systems, will affect the adequate performance of the heating system and reduce the component life of all components exposed to the recirculating flow.

An additional benefit of AquaClear SF includes the reduction of downtime associated with unit recalibration (USP Prednisone and Salycillic tablet calibration), since apparatus integrity is retained by the reduced activity of bath movement.



Technical Specifications

A P P L I C A T I O N S

Specifically designed to extend the life cycle of water in dissolution baths

S O L U B I L I T Y

Fully dispersed and dissolved at 37º C within 30 minutes. se gentle agitation

D O S A G E

One 10 gm dose will protect water for up 8 weeks. Static systems can be treated with same dose quantity

S A F E T Y

Avoid direct contact with skin. Immediately wash any contacted skin area with water. All active ingredients in AquaClear SF have been FDA and EPA registered and
approved. Detailed safety information available through MSDS

STORAGE

Store in original container in a dry area at temperature below 27º C (80º F) away from oxidizing materials, sources of ignition, and direct exposure to sunlight